When I posted my question, I was told that it was a pain to do, that many repairmen refuse to do it etc. ![]() Even that the front panel does not come off. Well, I am a fairly petite (by athletic) woman, and very far from being an expert at repairing anything. I just did it in less than 45 minutes with a screw driver and a pair of pliers (and a bit of common sense). Here is the protocol: 1- UNPLUG your machine 2- drain any water that could be left inside (at the bottom front right, you will find a small door: open it, the filter and the small black hose are there) 3. ![]() Put an old blanket on the floor behind your machine and a piece of wood long enough to go across the width of your machine- place it half way to what will be the height of your machine once it lies down on the floor- this will save your fingers in case you loose grip of the machine while tilting it down on its back. ![]() 4- tilt your machine back and down on its back: use your thigh muscles as the machine si a bit heavy (if you have a friend help you that will be easier-but I did it alone.
0 Comments
Leave a Reply. |